Sovol SV08 Mosfet Fan Bracket

A simple bracket to add a 8010 fan for the mosfet that controls the bead heating.

Make sure the sticker points down when attaching the fan! The bracket is mounted with m4 bolts and t nuts to the 2020 extrusion from the printer. 

Basic Fan Configuration in printer.cfg

[fan_generic fanX] #mosfet fan
pin: PA6
max_power: 1.0

The pin may vary depending on where you plugged the fan in, check the documentation!

You can add the new fan “fanX” in the START_PRINT and END_PRINT macros in the macros.cfg or sovol-macros.cfg to automaticly turn them on/off.

BOM

1x 8010 24V fan (Amazon or AliExpress *)

2x M4x8 bolts (Amazon or AliExpress *)

2x M4 t nut (Amazon or AliExpress *)

4x self tapping fan screws

*This link is a affiliate link, which means I may earn a commission at no extra cost to you.