Milwaukee M12 Nailgun Holder

I've been setting up my new shop and want to hang all my power tools and couldn't find a model for my nail gun. So, I made one!

It's a simple model and it has a little 1/8" slit in the center so you can level the print when hanging on a wall. The points of contact are on a diagonal for the nail gun and I didn't want to waste filament by making it big and square. Adding the slit was the best I could come up with to allow you to be able to make sure the nail gun is hung straight. The holes fit #6 pan head screws. I also put some glue on the back of the print but that was because I mounted it to some old ¼" plywood I had laying around and wasn't satisfied with the amount of bite my screws got. 

Hope you guys like it, I will update this file if I make any changes. Thanks!

{Printed with the following settings}

Filament: PETG

Infill: Adaptive Cubic @ 30%

Walls: 4

Supports on