LEGO Millennium Falcon 75375 Multiboard Mount

Printed Parts

• 1x Shaft
• 1x Base
• 8x Big Thread Multiboard Bolt (13 mm Big Thread, Flat Head, Bolt) 

*You can use less Multiboard bolts if you trust your filament to hold

Printing

I recommend printing with more perimeters and higher infill to make sure it is strong (I used 6 walls and 50% infill, overkill? maybe but I really don't want it to fall).

The parts are not already in the optimal orientations, the base should be flipped so the holes for the nuts are at the top and the shaft should be printed on its side. This means that you will need supports for the shaft as there are overhangs but it is much stronger this way.

Additional Parts

• 4x M3x12 Bolts
• 4x M3 Nuts

Assembly

Putting it together is straight forward, insert the the nuts into the holes on the base, then secure the shaft to the other side using the M3 bolts. Finally, use the 8 Multiboard bolts to secure it to your Multiboard and its done! 

Pro Tip: The bolts may not screw in fully at first since they are so close to each other but if you try straightening one of each set then you should be able to screw in the other fully.

Enjoy.