Monster Can holder for xiaomi electric scooter 4 pro 2gen

Its important to use the stiffest material you have and maybe some foam to increase friction so it wont slide down the bar

If you want to save filament, time and don't care about a rough surface on the lower part, switch to snug supports and “support enforcers only” or “everywhere” 

A simple model i made to learn a bit of Fusion.
It holds a 66.2mm can and clips onto any 40mm diameter bar.
I use it on my e-scooter.

Layerheight: Any
Nozzle: Any
Speed: Factory setting
Material: something UV-resistant like PETG, ABS or ASA
Infill: 5% is enough to hold the can 

📌 License Note:
This model is licensed under CC BY-NC.
Personal use and remixes allowed