This is an usb female pannel mount that allow you to screw it up to a pannel surface ( previously drilled to fit the connector size). This was mounted in the Car glovesbox. Nothing much is needed , you can print it flat on the table, like u see in the first 2 pictures (on the table , not like the 3D VIEW) , you will need 2 screw for plastics (2mm). No glue for the usb connector cause its very sturdy to insert in. The USB connector is 17.5 x 9.8 mm .
(Last Update )Added another version with cap.
Printer:
Anycubic i3 Mega
Rafts:
No
**Supports:**No
Resolution:
0.2
**Infill:**25%
Filament: Anycubic PLA
Notes:
PLA black Filament 1.75mm
Category: ComputerThe author marked this model as their own original creation. Imported from Thingiverse.