Core One Nozzle Wiper - Remix

V1.1

V1.1 has some minor updates based on some feedback.

All models have been tweaked to ensure there's plenty of clearance for the build plate, there have been reports that some users find that the wiper pushes up the corner of the build plate. This has been addressed so that the build plate clears.

The model with the M3 Bolt has had the hole size adjusted to make threading the bolt into harder materials a bit easier.

There is also now an option to use an M3 hex nut (DIN 934) with the M3 bolt for a really secure solution for those without heatset inserts. 

V1.0

This is a remix of @PCR_178847's nozzle wiper, there are 2 versions, one with the hole for the M3 bolt like the original and one with an option for an M3 Brass Heatset Insert (common M3 heatset inserts, the one I used is the one used for VORONs but most should be okay.

It uses the same silicon wiper as the Bambu A1 and an M3x8 Cap Head Bolt for either variation. 

I have a model of a purge bin you can use with this wiper, please take a look!

@PCR_178847's instructions were great so see those below or on their original model.

Warning: You will loose 1mm of Y Travel at the X location of the brush due to the part cooling fan.

Hardware needed.

• M3x8 Screw
• A1 silicone Wiper
• Printed part
• Heatset insert (if choosing that model)

Install:

• Put the silicone on the printed part
• Screw the wiper on the bed holder 
• Change Slicer Start  G-code

from:

G29 P9 X208 Y-2.5 W32 H4

to:

;G29 P9 X208 Y-2.5 W32 H4 ; original nozzle cleaning method
G0 X40  Y-14 Z1.5 F10000;
G0 X76 Y-18 Z1.5 F10000;
G0 X40  Y-14 Z1.5 F10000;
G0 X76 Y-18 Z1.5 F10000;
G0 X40  Y-14 Z1.5 F10000;

Please double check the positions with manually moving the toolhead via the LCD

As always, please check your positions and start g-code before running the printer!

V1.1

V1.1 has some minor updates based on some feedback.

All models have been tweaked to ensure there's plenty of clearance for the build plate, there have been reports that some users find that the wiper pushes up the corner of the build plate. This has been addressed so that the build plate clears.

The model with the M3 Bolt has had the hole size adjusted to make threading the bolt into harder materials a bit easier.

There is also now an option to use an M3 hex nut (DIN 934) with the M3 bolt for a really secure solution for those without heatset inserts. 

V1.0

I changed this a bit as I found the cut out on the original for lifting the corner of the build plate was too small, I found having the part angled made getting the build plate off much easier. I added the hexagon pattern for aesthetics and changed the shape slightly for a larger area around where the nozzle brush sits.