Pivot Display Stand - RC Cars

This is a pivot-ball-adjustable RC car stand for you to display your prized RC car collection!

Overview

There are 3 post heights (plus a short non-pivoting post plus a small plinth which is handy for 12th/10th pan-style cars or similar. 

The position of the pivot/display platform can be adjusted by loosening the two bolts clamping it and moving to the desired angle - noting it will move through about ~45degs from horizontal in any direction up and down. There are 6 optional holes in the platform to attach the pegs that enable you to position your car/model as desired without it sliding off the stand!

Experiment with the angles and peg positions to best display your car :-)

I have also made the finished printed product (incl. hardware and adhesive pads) available on my shop: www.GrandPrix3D.store

Assembly

Requires min. 4 to ~8 of M3x16mm counter sunk bolts (Note: for the USA standard hardware; you could probably get away with equivalent length 4-40x5/8" bolts, but be careful not to strip the threads as 4-40 is ever so slightly smaller dia.)

Suggested example source at RC T-works for the bolts.

You will need 4x bolts to attach the base/post/clamp/platform (ie 2x for the clamp). Additional bolts are used depending on the quantity of locating pegs for your desired setting, they require 1 bolt per peg.

You can stick rubber or felt pads if desired to the underside of the base to suit your display surface.

Refer to assembly exploded diagram image for reference.

If you love this model and would like to send me some dollars, please do at: PayPal.Me