Filament cutter cable clip for Qidi Plus 4

Discussion

A quick easy to print replacement for the filament cutter arm mount/cable clip for the Qidi Plus 4.

The cable clip on the stock item is very easy to break.  Print both of these to replace it easy with a much stronger solution.

Use 3 of M3 square nuts inserted into the slots.

You will need an M3x20mm bolt to attach the stock cutter arm to the new mount.

Attach the mount to the extruder

Insert spring into position.

Slide the arm into the bridged opening.  The bridged opening serves to limit the arm's swinging range.

Bolt the arm into place with the stock axle.

Route your cables, and then clamp them to the bracket with the supplied clamp.

Support

Enjoying my work?  Buy me a coffee!    https://ko-fi.com/stew675