Dungeons and Dragons Status Effect Markers

These Rings fit the standard Figure size like you get them from Heroforge.

The case fits 6 Rings each.

Printing Instructions

Basic Rings

Just add a Color Change at 1.2mm. PrusaSlicer ≥2.4.0 will automatically suggest this.

Exhaustion Ring

First print the upper Ring (the one saying “Exhaustion”) with a color change at 1.2mm.

Then Print the lower Ring (the one with the digits) with color changes at 1.2 and 2.6mm. When doing the second color change, stick the upper Rings onto the lower ones. As the print continues, a nice cap will be formed, keeping the upper ring in place. To keep the two parts from sticking together, apply some PVA-based glue (like the one that comes with the rolls of Prusament PC Blend) to the top surface of the upper Ring before sticking it onto the lower Ring. This glue can be removed from the finished print by soaking it in handwarm water.

Case

The lower part can be printed without any special measure.

The upper part is intended to be printed with a MMU. If you dont own an MMU, simply remove the Rings from the list. The file is still easily printable and you will get a texture change instead of a color change.

Presliced Files

The presliced Files have 9 instances of the rings on them, even though the Case only holds 6 each. This is because i found that sometimes they dont print very nicely (due to the nozzle not being primed right after the filament change etc) and printing spares is easier than printing a whole new batch due to one coming out weird.

MMU

The Files assume the base color is Filament 1, the accent color (the rings on the case and the text on the rings) is Filament 2.

Non-MMU

The files contain manual filament changes. The normal rings have one change, the bottom of the Exhaustion ring has two. 

Mini

The Case is too large to be printed on the Mini, it is therefore not included. The Rings contain manual filament changes.