Philips Oneblade Wall Mount and Charging Station - Easy and Fast Print

Your choice of materials, infill, etc… Just don't overtighten the screws in a stud and you'll be fine. I printed from PC on my Qidi plus4 at .15 layer height with 15% infill.

The body pocket is based on my 3d scan of the oneblade, then offset .5mm so it fits perfectly. There is a hole at the bottom of the pocket for charging.

This stand fits 3 replacement blades, and 2 combs.

This design is original, designed from scratch by me, but was inspired by this excellent, larger wall mount.