Creality Ender 3 V3 SE - Extruder Stepper Motor Cover (for debranding)

I recently replaced the fans on my Ender 3 V3 SE with a more custom setup (using incredible designs from Emil Sadkowski), but as a result the standard Creality cover for the whole assembly no longer fit. I didn't like the Ender branding on the stepper motor, so I designed a snap-on cover to hide it.

There are three versions.

1. All screws visible
2. Only middle rotating-screw visible.
3. No screws visible.

While it should just snap into place, I would strongly recommend using hot glue or a strong double-sided tape to hold it in place.