Deadpool - Hueforge

Original design - Hueforge of Deadpool
The photos shows the result in 200*150mm and a nozzle of 0.4

You can change the X and Y dimensions but do not change the Z dimensions  
You must define the printing parameters indicated in the description below and change the filament on the indicated layers.  
You can use filaments other than those indicated, but the result will differ.  
You can use any black PLA

Hueforge description
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 149.69x200mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 1.5mm

Filaments Used:
    PLA Black
    PLA BambuLab Basic Jade White Transmission Distance: 5
    PLA BambuLab Basic Marron Red Transmission Distance: 1.3
This print uses 3 unique filaments

Swap Instructions:
    Start with Black
    At layer #6 (0.56mm) swap to Jade White
    At layer #11 (0.96mm) swap to Marron Red
    At layer #13 (1.12mm) swap to Jade White for the rest.