Sovol SV08 BTT HDMI7 v1.2 Case and Mounting Bracket

A simple case and mounting bracket to use BTT's HDMI7 v1.2 on a Sovol SV08. It mounts on using lugs like the original screen. Will probably block enclosure doors if you have them, I don't have the enclosure kit. I think it'd need a different bracket to lower the screen so it doesn't block the doors. Prints in two pieces and screws together. The bracket may be a bit of a tight fit depending on your printer tuning/settings, just use a needle file on the inside faces if so. It needs to be tight to prevent any wiggle. 

Hardware:

4x M3x8 screws (Countersunk)
4x M3x12 screws (Countersunk)
4x M3x4x4.2 heat inserts w/ a starting OD of around 3.85mm

Print instructions:

See picture for orientation. Supports required for bracket, optional for main body case. Other details aren't really important, just go with what sounds good.