Lens Caps (one part print) Low Profile

This is a modification of the lens caps from @BoopidooDesigns https://www.thingiverse.com/thing:4418284.

Print Settings

Rafts:

No

Supports: 

No

**Resolution:**

0.4mm nozzle; 0.15mm layers

Infill: 

50%

**Filament Material:**

ABS

Notes: 

For best results, set the bridging angle to 45 degrees in the slicer settings.
After printing, scrape the sliding surface with a flat screwdriver.

If you have trouble separating the spring mechanism from the lens cap body, here is a short video tutorial about post-print processing:
https://www.youtube.com/watch?v=2Jwt3H3o6YU 

Category: Camera

I reduced the depth of the caps to use them with low-profile slim lens filters.