Dr. Gusman Logic Analyzer Case

Design for the v6.0+ PCB design by Dr. Gusman

Does not support board chaining.

I would suggest printing the bottom piece with the open side up and the top piece with the open side down. If you have a textured bed, I also would suggest a 1 layer raft on the top piece to preserve the surface finish. The spacers go between the PCB and the Top cover(3 needed). I made the model to work with m3 because I don't have an m2.5 so you will need to drill out the mounting holes on the pcb a little bigger.

Requires 3 x 12mm m3 screws(10mm can work if that is all you have)

Optionally you can add a 2mm diameter acrylic rod to the LED indicator hole to make it more visible 

Pin tag was printed on normal paper at 600dpi and glue in place.

Click here for the project

4/11/2025 Updated to add a larger label with switch indication. Also added a channel for the LED indicator