Tea Bag Storage Drawer

I needed a way to organize the various teas that have accumulated in our kitchen cupboard over the years. Inspired by similar models, I came up with this: a simple drawer in a box. The front holds a tea bag as a sample.

I glued 14 of the boxes together and then glued them to the underside of my cuboard shelf using double sided tape.

Each drawer is long enough to hold more than a typical box of teabags. This way you can refill before you run out.

Print the box on it's back, the drawer on it's bottom. The spacer is optional it helps keeping the bags upright when the drawer isn't full. You should print it on it's side for best layer orientation. I would recommend a mouse ear brim for better bed adhesion. No supports needed.

3 drawers and 3 boxes just barely fit together on a BambuLab P1/X1. They print in little over 5 hours with the standard 0.28mm profile in High Speed PLA.

If you want to modify the model, here's the OnShape File.