Sunflower clicker

The next member of the table garden is arrived!

The little cute garden is growing!

Keep your hands busy while you're working. This cute fidget toy is satisfying not only for the eyes, but also for the ears.

I made a cheat sheet, to make the assembly easier.

All the flowers are compatible with the basic pot and soil. Change them and your table will never be boring. 

I used the blue switch from amazon.:ttps://www.amazon.de/dp/B08SK47VDX?ref=ppx_yo2ov_dt_b_fed_asin_title

SETTINGS:
Nozzle: 0.4 mm
Layer height: 0.2 mm
Infill: max 15%
Center: FUZZY SKIN! It takes it on a higher level.
Center back: Simple print, no brim, no support.
Petals: Simple print, no brim, no support. 
Stem: Support on the bottom and the very end. The sideholes are working without it. 
Leaves: Maybe brim, but works without it. Both has a flat side. 
Soil: No support, print it upside down
Pot: Outer brim

I set the seam allways to the backside. Use concentric top layers.

All designs are free for private use only. You are welcome to purchase a license to sell printed models on my Patreon or just support me!
https://www.patreon.com/c/csicsu