Pick of Destiny Guitar Pick - works

This pick is thin with just a few layers thick, but works surprisingly well. I printed the one in the image in PLA but would be interested how one would work with the different properties of PETG, ABS, or TLA (post makes below!)

Print Instructions: printed on Ender 3 v3-SE (Cura slicer)

+ Standard printer settings will work with this file.

        Nozzle: 0.4mm

        Layer Height: I used 0.16mm (0.2mm will work)

        Infill: 100%, this thing is all layers

        Temperature/Material: dependent on filament recommendations

        Supports: No

        Build Plate Adhesion: Skirt

        Model Orientation: Print with flat part of pick facing down.

        Post-Processing: None

+ I used PLA for this print, however, if you're concerned about durability or other properties, this can easily be printed in PETG or ABS.

+ The design was simple from a *.png file I created in Gimp (free photo editing software) and exported as 3 separate layers as SVG files.

*I am not an affiliate with Tenacious D (although I wish I was)