Astrobot Figure Reinforced

This is a remix of the linked Astrobot model and is intended to be a simpler one-piece print.  It has been reinforced so it is less likely to break and it trades some character accuracy for that additional strength.  For example, the antenna on top is too large and short, but is less likely to break off.  I added additional reinforcements to the arm joints, leg joints, and the neck area.  I also added pads under the feet so it can stand on its own.  Note that the little finger joints do break off very easily and I have not found a solution for that, so I recommend removing them if that concerns you.

I printed this with a high infill density (75%) for additional strength.  I also used a raft and supports.

Note: Even with the reinforcements small pieces of this print such as the arms, legs, and antenna could break off with hard-enough force and could be swallowed by either people or pets.  Use at your own discretion.

Made into one-piece print by adding antenna on top. Added pads under the feet.  Added reinforcement to the arm, leg, and neck joints.