FormD T1 2.1 & 2.5 Travel Bracket for RTX 5080 Inspire

This is a rear bracket for the Formd T1 v2.1 and 2.5, specifically designed for the MSI RTX 5080 Inspire. This greatly reduces wobble on the GPU especially for people who travel a lot with their PC. I use this and a remix I made of Eigas anti sag bracket on the front to reduce any wiggle from the GPU.

It uses one M3 thread on the rear of the case, and one M3 thread on the metal shield of the GPU.

Will require removing the screw in the GPU. 

Edit: Added v1.1 in the files per user request. This version has 16mm long holes for the screws, the top portion is 2mm thicker, and bottom is 1mm thinner, and the distance from the HDMI port to the plastic has been increased (cut 2mm from model).

This uses standard M3 screws, 

1. M3x12 for the GPU - original screw has loctite on it, so would recommend it as well, but I havent used any on mine and have not had it dislodge.
2. M3x6 for the Case - dont go too hard on this one as one of the 2 holes may push on the GPU. Go just a bit tight. If youre not sure, use an m3x4 or m3x5mm screw.