A Simple Spinner

It's a simple spinner! You can slide, spin, shake and uhh… tilt? I don't know, I just wanted it to spin.

All you need is:

- a 3D Printer

- Filament of your choice (this was done in PLA)

- Super glue

Recommended settings:

- Infill: at least 20%, hexagon/tri-hexagon

- Layer height: 0.2mm (I printed with 0.12mm)

- Wall thickness: 1.2mm

- Supports touching plate, with the indents for the holders facing towards the plate

Assembly Instructions:

- Put Holder - Bottom on a table or flat surface

- Slide the Main Body onto Holder - Bottom

- Put super glue into the hole of Holder - Bottom and the shaft of Holder - Top (make sure that the glue does not leak onto Main Body)

- Insert Holder - Top into Holder - Bottom and wait for the glue to dry

Do not put your prints near a naked flames / candle else it will have that burn mark. Or do, I'm not your parent. (Just kidding please do not ever put your prints near any flames)