Upcycle empty filament roll to cable reel

Provides two parts that screw in place. Big knob to have good grip. Spool can turn freely with little resistance.  Turn spool by hand either horizontally or vertically. 

Dimensions: Spools of up to 70mm height and min. diameter of 52mm may be used.

I have drilled a hole to get the cable through. If you do that please make sure there are no sharp edges that could cause damage to the cable. You will need a separate assemble plug on at least one side of the cable since you might have to cut off one plug in order to get it through the hole. 

Have fun!

No supports are needed.

I did print this with…

0.20 mm layer

25 % infill (bottom part) / 5% infill (knob)

bottom part: flat part first / knob: smaller part first (knob upwards) (as on photograph)