Inquisitorial servo skull

The hollowed-out servo skull allows you to conceal various electronics inside, such as a laser, LED, webcam, etc.

The two halves of the skull are designed to be held together by cylindrical magnets (6×2mm).

For mounting, a screw-in plate can be used, and additional parts can be modeled to fit the 25×20mm opening between the halves. The back half includes three slots for M4×6mm heat inserts, allowing the mounting plate to be securely attached. An example mounting plate is provided with a Ø16mm hole, which can accommodate a cable gland or similar hardware.

Some areas of the hollowing are not optimal, which may make support removal more difficult. I might create a version 2.0 to address these issues.

Updates 

14.04.2025

Added pictures of build with camera and LED inside

07.04.2025

Mounting plate with Ø16mm hole is slightly bigger and with added slots for screws to make it easier to align the cable gland (original one could have issues with cable gland nut interfering with the rest of the model and not allowing it to sit right)

Split to parts to be easier printed and hollowed out so its possible to add electronics inside