Simple USB and SD card holder with tray

A little organizer for all your portable media storing needs! 

Featuring 8 of the classic USB slots (And 3 USB-C slots if you're feeling a little fancy), as well as 4 SD card and 7 Micro-SD card slots, this baby has all the portable media storage that you've been looking for!

Tired of those pesky little screws rolling around on your table? Well worry no more! For this organizer comes with a small (But effective!) tray with a lip around the edges to make sure that your favorite little screws will be kept safe until you need them!

I printed this model on a stock Ender-3 using these settings:

Layer Height: 0.2mm

Infill: 25% (Lower than that should be fine as well)

Infill Pattern: Gyroid

Top Layers: 3

Bottom Layers: 3

Wall Count: 3

Adhesion Type: Skirt

If your printer is known to struggle with bed adhesion then I recommend using a brim rather than a raft, due to the models relatively small footprint (87 x 42mm).

I hope you enjoy the model! Please leave a comment if there's anything you wanna know or if you want a slightly tweaked variant (More USB slots etc.) and I'll gladly make it and add it to improve the experience for other users :).