Corolla E210 Touring Sport - Parcel Shelf Load Cover Extension mount clips

Models are positioned as they should be printed (clips needs supports).

Each side requires:

• 2x M3x10 (either socket or button head cap screw)
• 1x M3x6 (button head cap screw preferred, but socket head cap screw may be used as well. In some cases 8mm length instead of 6mm might be necessary)
• 3x M3 nut

At least PETG should be used (I used ASA). I don't think PLA is good material for this purpose (due to potential hot conditions inside car).