NZXT H700 GPU Support Bracket

Inspired by this GPU support but the designs are so different I didn't end up calling this a remix.

This is a GPU support bracket for an NZXT H700i or NZXT H700 case. It fits my GTX 1080ti Founders Edition, which means it should also fit a GTX 1080 FE. I haven't tested it with any other cards.

I have an NZXT Kraken G12 GPU cooler on my card, so it doesn't have any of the stock cooling underneath the PCB.

The NZXT logo will need a bit of post-printing cleanup since I included a few 0.5mm supports. Just cut them out with a small knife. Print it without any additional supports.

Hardware:

I would suggest you print this in PETG since the inside of your case may get a little toasty sometimes.

Print instructions

Unassociated tags: GTX 1080, GTX 1080ti, NZXT H700

Category: 3D Printing Print Settings

Printer Brand: Prusa

Printer: i3 MK3

Rafts: Doesn't Matter

Supports: No

Resolution: 0.2mm

Infill: 20

Filament: AmazonBasics PETG PETG Black