Rock Shox Rear Shock Bearing Installer (3/8" drive)

This is a simple socket for installing (and removing) the Rock Shox rear shock bearing kit. It designed to accept a 3/8" socket driver.

I recommend printing it solid (100% infill). It's only a 10g part.  

It should be fine, even in PLA, to install the bearings at the recommended 10Nm, but no guarantees. As always, make sure you use a torque wrench. 

I've also added a second socket with dramatically thinner outer walls for upper housing bearing installations (instead at the end of the shaft). This is because there's very little room between the upper housing and the bearing cups. Final torquing might still require a crow's foot depending on your shock.