Anycubic Kobra S1 Door Hinge Seal
Door Hinge Seal for anycubic Kobra S1
51
254
5
1547
updated March 31, 2025
Description
PDFHinge seal for the Anycubic Kobra S1 to improve heat retention
Recommended material is PETG, ASA/ABS, PLA
Supports are required
Total filament used is 2.5g
Tags
Model origin
The author remixed this model.
Differences of the remix compared to the original
- Added small pin 1.2mm x 1.4mm to secure seal a bit better
- Reduced the spacing between the two locking pins slightly
- Extended the secondary pin by 3mm
- Made a minor adjustment to the top part's geometry
