TPU / Flex Cable Zip Tie

A cable tie for printing from TPU!

3 wall lines and 30% infill should be enough for a good stability. To make the cable tie softer, you can set the top and bottom layers to 0. Then only the perimeter and the infill will be printed. In this way, a soft cable tie can also be printed with a fairly hard TPU.

There are two different lengths, each with one and two holes to fix the cable tie permanently to the cable if you want.

Upon request, I've also added a folder with zip ties for harder flex filaments. These have slightly larger holes.

If you like check out my other designs too!