Makita Brand Logo for HSW

Choose your favourite colours and print out a Makita logo to show off your love and appreciation for your favourite tool brand and modular storage system, the HSW!

Logo prints flat with the seen side facing up. Remember to add a pause/filament change midway through for the 2 tone effect. Logo printed in PLA and Plug printed in PETG, however I would assume it would be fine for both models to be printed in either filament.

Assembly 

Print out logo and plug. Insert plug as seen in the photo and push down hard to click it into place. It is not a heavy duty fit, but it is plenty strong enough to hold the logos weight. Push the “holee” end into an empty insert in the HSW. Enjoy!

Suggested Print Settings

Layer Height: 0.2mm

Infill: 100% (For strength)

1 wall for top surface

Logo is compatible with HSW system, no additional hardware required.