Guitar AMP - Scale Bluetooth speaker case

I made this as an accessory to go with my ⅓ scale Ibanez RG Series Guitar.  It can be printed to use the same speaker I found on Amazon HERE, it can also be printed with an open base (file included) to add your own similarly sized speaker, or just print it to display alongside the RG or JEM scale Guitar models.

The model is divided into 8 .3mf files and uses 3 materials (PLA Galaxy Black, Black, Gray @ .030/.020/.010mm wFuzzyHair).  Substituting the Galaxy Black (small silver specks) with just black for the entire case works fine.  The galaxy black is just a bit of detail for fun. Two parts "AmpKnobs" & “ButtonPlate” require a color change (already in the .3mf). If the filename has multiple colors listed, that run will require a color change at a specific layer.  (for more info on color changes see THIS)

***STL available but I highly suggest using my .3mf files.***

*If using this case with the same speaker, print and use the "Button_Plate".  it helps with the tiny buttons and holds the speaker in place.

**The Speaker Grill Mesh only has a gcode file, no STL.  The part is actually just a slab shape at the necessary dimensions and print settings.  The part in reality is a rectangle without a top or bottom layer so you only see the perimeter “frame” and the infill “mesh”.

Assembly  -  Glue Is Required, please see pictures. I used Gorilla Super Glue Gel

The main body for the amp has a few slots the other pieces fit into.  The "AmpTop" needs the small support arm trimmed from the part and then it gets glued over top of the amp body. 

Check out my other related model: Guitar Stand w/Cable , Guitar Strap