Playing Card Case (Parameterized)

I took the liberty of parameterizing the .f3d model to make it easier to adjust the size. Right now it is for 88mm x 63mm cards.

To resize:  set the “CardLen”, “CardWidth”, and “DeckThick” parameters to the actual size of your cards and it will add clearances (except for DeckThick - there is a parameter set to 0 that you can adjust called “DeckHeightExtra”).

I print this with the drawer set flat on its bottom, with snug supports below the pull tabs on each side.  The outer box was printed on the flat end, with a 5mm brim to ensure it stays put on the print bed.

Printed:

• 0.4mm nozzle
• 0.2mm Structural
• PLA
• 15% gyroid infill
• snug supports on build plate only should work (although I painted mine under the two tabs on the drawer)

My prints could have been improved by painting the seam on a corner of the box - note the seams above some of the symbols on the top of the box.  I have done this for the .bgcode and .3mf files.

(BTW the photo shows that the green box was 5mm too wide for my cards - lesson learned, always measure twice and print once!)

Modified the Fusion360 .f3d file to make it parameter-based.  Adjusted the size to fit my 88 x 63 x 16 mm playing card deck.  Added debossed card symbols to the top of the cover.