Artillery Sidewinder X1 X Ribbon Cable Support

I wanted to secure the cable to minimize the chances of joining the ranks of people with burned out cables and connectors. I also wanted to remove the cover as it does nothing useful. It just reduces airflow to the motor and makes service more work.

This mounts to the card using the existing screws in those locations and the clamp needs an additional 2 m3 nuts and 2 m3x10 or longer screws. I put a little tape on each side of the clamp to help grip the cable.

I also put a little dielectric grease on end of the ribbon to fend off corrosion which could also cause a hot connection.

Print instructions

Category: 3D Printer Parts Print Settings

Supports: No