Swiss army knife 58mm scales

Special feature is a scale with two slots for both tweezers and toothpick and optionally a side slot for a pin/needle (useful for removing SIM cards for example).

An addition is a pen scale which requires pen and plastic part from original SAK.

All variants (dual slots, dual slots with pin, pen, simple) come in standard SAK compatible holes so that they can be directly snapped on to a standard SAK and in version with screw/nut holes for custom works.

I got the best results with 0.1mm layer height. Some 400→800→1000→2000 grit sanding and is recommended afterwards for best results. Also, some light modifications with a scalpel might be needed, especially with pin slot, depending on the quality of the print.

I printed it in PLA and after a few weeks of carrying it on the keychain in the pocket with other stuff there are no signs of any damage.

BTW, I haven't tried putting the last iteration of scales on unmodified SAK (i.e. without screws) so please comment if there are any issues