DJI O4 Lite 19mm snap-fit camera adapter

2 models, newest has some top protection for wires against blunt impact (forgot to smooth corners sorry).

READ: With the camera removed from stock hardware, the camera will snap into place for TPU prints (please only use TPU!). If you need to remove it, it takes some finesse with shimmying it out as you flex the mount.

The camera mount is then installed using two flat square nuts that fit into a recession in the model, then suitable screws for your build are used. I suggest running washers with your screws. If you use too long of screws then you risk damaging your camera, be mindful of that as the TPU compresses.