I have a bunch of different Raspberry Pi boards needed within reach to easily test something. So they are all different versions of the board. I was looking for a way to store them nicely and found the wall mount project by Dimsch. I used the wallmount-piece to create a holder and reworked the board-holder to two new versions for the Raspberry Pi Zero which is smaller and V1 without mounting holes.
After printing 5 of the Pi-holders, I found out the screw hole of 3mm was a bit too wide as this is the same size of the hole in the board itself. So I created some small pieces which fit in the 3mm-hole but can be used with a 2mm-screw.
Full description on my blog: “A 3D printed Raspberry Pi Organizer”
The author remixed this model.