Eiffel Tower K-Cup Holder

A k-cup holder perfect for storing your French roast!

I made a k-cup holder that uses the tower posted by LeFabShop as a frame for 2 holders that are glued in place. I simply scaled the tower up 4.5X to 202.5mm tall. I created some supports for the arches since I was concerned that could be a bit messy without. With my supports it printed pretty nice.

remix of:
https://www.thingiverse.com/thing:311002

Print instructions

Category: Household Print Settings

Rafts: Doesn't Matter

Notes:

I suggest .15 to .2 mm layers and 3 to 4 perimeters if you are using a .4mm nozzle. 15% infill is enough for the tower. I printed the holders with a higher infill- I think it was about 30%.

I have provided two options for the tower. One without supports that you can add your own supports to as you like and one with my support structure.

Post-Printing

Remove supports from the tower (if you used my supports). I worked an exacto knife between the supports and arches and carefully cut & worked them free.

Glue the holders in place. The top holder was a good snug fit for me, but could be a bit tight depending on your printer.