Z Height Jig

This measuring simple jig fits between the top of the z-motor mounting plate and the bottom of the x mounts. When it fits about the same on both sides you should be good to go! -Alternatively you could make two of these and lower your z until it bottoms out on both.

My printer as it is setup up currently rarely needs any adjustment if the bed is well leveled once. I just do a quick 4 second check with the jig after homing and about 10% of the time I may need to turn a z motor a click or two.

Print instructions

Category: 3D Printer Accessories Print Settings

Printer: Tronxy P802E

Rafts: No

Supports: No

Resolution: .2

Infill: ~10%

Notes:

Flip the model flat on its back. Then scale the length to your needs. It is 100mm long to be easy to scale. My setup happens to require 77MM. So I would scale in one dimension to 77%.