Replacement, tighter tolerance gear selector bushing upgrade for common Suzuki cars. This was originally created for my 2004 Suzuki Ignis Sport however this should also fit alot of other Suzuki cars with similar gearbox designs such as swifts, jimnys and WagonRs, particularly ones using an M series engine (M13A, M15A, M16A, etc.).
The bushing has two X/Y dimensions. One at 13.8mm and one at 14mm. Use the one that gets you a better fit or sand down the oversized side to fit.
The center bore is supposed to be 10mm and is unlikely to print perfectly therefor a 10mm drill is almost certainly necessary to bore out the hole.
This should ideally be printed out of a material with a low friction coefficient such as Nylon. I printed mine out of Nylon trimmer line. Make sure to also grease all related surfaces.
The author marked this model as their own original creation.