Livestock Water Tank Heater Nut

This is a replacement nut for attaching a livestock water heater. I made it much thicker than the original both for strength, but also just so it was easier to turn on. It was a tight fit at 100% scale, but still usable. I printed again at 101% (x&y only) and it was just right. I printed with both pla and abs. I will use the abs one and keep the other around just in case.

Print instructions

Category: Outdoor & Garden Print Settings

Rafts: No

Supports: No

Resolution: .2 mm

Infill: 20% max

Notes:

Obviously, you need to rotate it flat to print.