Ford Model T FACT (Ford Arduino Coil Tester)

This is an enclosure for the FACT (Ford Arduino Coil Tester).
See more here: https://www.mtfca.com/phpBB3/viewtopic.php?t=9072

You will need:
4x M2 screws and nuts
4x M3 screws and nuts
9x M4 screws 
3x M4 nuts
and all the electronic components…

Make sure to isolate the high-voltage screw and wire! Otherwise, the spark could jump to the Arduino/PCB (Ask me how I know…).
Also make sure to perform the testing process in portrait orientation! (As it is installed in the T).

Note: I only created the enclosure; I did not design the PCB!