GetFort Rack vent cover (inner diameter 114mm)

Hi.

I've designed a vent cover for GetFort rack. I'm using this rack as an enclosure for my printer. This vent cover design is meant to protect inside from dust and trap heat in. 

The vent lid is positioned on top of a base using a single pin, and it is centered by magnets. 

Due to the magnets, the vent cover locks itself in three positions. 

I've attached the base to the rack using double-sided tape.

Design uses:

-8 magnets, d = 5mm, h = 1.6mm 

Base inner diameter is 114.3mm

In the future, I plan to design an adapter that enables using the base of a cover as a dock for fume extractions. 

Print Settings

I advise printing with PETG

Supports: 

No

Infill: 

15%