Miele fridge freezer handle

Because of tight tolerances the filament need to be dry befor printing. It has been successfully printed with ABS, 0.4 nozzle and 250C on K2 Plus. It will probably work just fine with PLA or other filaments as well. 5 wall layers, bottom layers and top layers.

Distance between holes are 18mm. Standard support inside the holes.

It is not perfect, but is working very well and is making opening a breeze even when the door is vacuumed and normally hard to open.

After breaking the insanely expensive handle, I decided to draw an alternative that was supposed to work at least as good as the one from Miele and I think I succeeded.

This version has not been printed by me after doing some small adjustments. The clearences are increased slightly for easier printing, and the shape has been changed as well. In case of many downloads I will consider to make a more refined version.

Print time on my printer is about 100 minutes with precise wall added and quite slow print speed.

Left and right version added. Glider pad to be glued on fridge or double sided foam tape.