Logitech Shifter Screw Clamps - Fully Replacement!

Since I bought a used shifter without any mounts, and so far I have only made a model of the lower main screw, I decided to make a model of the two remaining clamps.

To print:

1. MainUpper - 2x

2. MainLower - 2x

3. Clamp - 2x

4. Peg - 4x

We also need:

1. M6x100 screws - 2x

2. M6 nuts - 4x

3. M6 nuts with a rounded tip (I don't know what it's called exactly) - 2x

The assembly process is trivially simple:

We put the screw in the "MainLower", press 2x "Peg" into the holes and put "MainUpper" on it - we can also use some glue, although in my case it wasn't even necessary.

Next, we have to put two nuts in the "Clamp" - one at the top, the other at the bottom. After mounting it in the Shifter, we screw the nut with the rounded tip on the bottom - that's all. :)