Barrina Grow Light Light Stand - 3 segments

The original design was great but I needed a taller stand to be able to reach the top of bigger plants. I also didn't want to have the lights hanging from the ceiling. After some trial and error, I end up with a screw design that can be printed with no supports.

Lastly, the original design didn't fit the hight of my printer, so I had to account for that as well.

I used the same measurements as the original version by @LeeWeaver_1455094 with a few changes:

1. It is now detached from the post and can be printed without supports or brims
2. has a screw design to attach anywhere as long as it has the same screw design

I'll include 3MF and Fusion 360 as well.

Print instructions are on the 3MF, but overall I would say:

1. Use PETG. The lamp doesn't seem to get too hot, so possibly PLA as well
2. Use brims to hold the pipe up. It is a big print and it failed once with me. I added 10mm brims and honestly it might be too much
3. No need for brims on the base and top cap
4. 2 wall loops should provide enough strength. I personally use 3. The top pipe was very fragile around the first due to layer line weakness, but the center hole fixed that completely

Inspired by this design and adapted to fit my own use case. Kudos to the original creator @LeeWeaver_1455094

TLDR for the changes:

1. top adapter is now individual part
2. 3 segments to increase the total height
3. base is also individual part
4. adjustable height on printed parts (using the screw design) and on Fusion 360Fusion with parametric design for easy customization (although not fully bulletproof)