Mk3 Steel Sheet Drawer

This mod is heavily inspired by the Prusa Mini Base mod.
https://www.prusaprinters.org/prints/63483-prusa-mini-base

I always wanted a place to store my MK3 steel sheets in an organized way, without taking up additional bench space. When I saw the Mini Base Mod, it hit me in the face: By widening the stance of the front legs, I could fit the sheets underneath the printer.

This mod raises the printer about 32mm, 1,25", or 4 barleycorn.
No disassambly required.
All you need are six M3x10 screws and hex-nuts. 
It uses the original rubber feet. 

Print in PETG with at least 20% infill, no support needed. The acented parts are press fit. If your printer is well calibrated, they should slide in with a little bit of force. If they don't, use sandpaper. 
Slide  M3 hex nuts into the T-nuts from the side and pre-screw them onto the parts.