Helldivers 2 Coaster

If these become popular I will expand library of stratagems. 

Printing:

I usually do a typical .2mm layer height. the black top files will need to be flipped so that the top is facing down. added bonus if you have a textured bed. the colored layers turn out really good with ironing topmost layer enabled.

Assembly: 

some of the pieces will need some motivation to put together but I prefer the tighter tolerances. Some models require an additional small black piece to be printed and should be printed like the colored layers. for the feet I used these rubber feet. Once the all the layers have been pressed together, glue the upper and lower half together. use glue sparingly around the edges to avoid it seeping out and ruining your finish. If some does leak out just wipe it off ASAP. once the top and bottom have been brought together clamp them down aggressively or if you have a vice that will probably work better than what I did.