T-Fal Vegetable Knife Replacement Handle

Handle broke on this knife, made a replacement.
1
9
0
30
updated March 18, 2025

Description

PDF

Requires an M4x12 FHCS and an M4 nut. (Ideally in some sort of stainless steel.)

Reminder: knives are sharp - a catastrophic failure of this print could cause serious injury!

Recommended material: ABS, so it can survive in a dishwasher.

Print settings considerations:

  • lots of perimeters (I used 8)
  • high infill (I used 40%)
  • print hot and not too fast to maximize layer adhesion
  • seam alignment to the rear

Model origin

The author marked this model as their own original creation.

License