120 Bit Storage box

Remix of the 96 Bit Storage Frog Box. 96 just wasn't enough. I needed a 120 Bits storage.

Thanks to TheSameNameTwice for the original version or the thingiverse remix.

https://www.prusaprinters.org/prints/52466-96-bit-storage-frog-box

You can use various m3 bolts to hold the parts together. I used what I had by hand (M3x25). They could be shorter (20mm) and still should work. Those nuts are not needed. Just added them because the bolts were too long anyways.

The lever cant be connected by a bolt to the holder, because the heads would be in the way. A 2mm steel pin or in my case a piece of filament work out there.

Printing:

Depends on the printer. I did it on my voron 0 with abs aswell and could go much faster than with my mini. The small  parts need quite some cooling for nice outlines. The big parts are scaled by 2% to make the bits fit even with worse tolerances if you decide to go faster.

following settings worked out to be stiff enougth:

• 0.4 nozzle (0.42 line thickness)
• 0.25 Layer height
• 15% infill (gyroid)
• 3 bottom, 4 top layers