Project Mat
Printed with TPU, fits the bits from the iFixIt screwdriver kits. Prints wonderfully at about 30 mm/s and 240 degrees.
16
88
0
788
updated
November 26, 2019
Description
PDFPrinted with TPU, fits the bits from the iFixIt screwdriver kits. Prints wonderfully at about 30 mm/s and 240 degrees.
Next I probably need to enlarge the holes just a bit more as my TPU shrunk to where it is slightly too snug. Also want to try doing 1-2 layers of PLA or PETG then the TPU to add some rigidity.
Print instructions
Unassociated tags: project mat
Category: DIY
Tags
Model origin
The author marked this model as their own original creation. Imported from Thingiverse.
